The Andis T-Liner Trimmer is a popular hair clipper. It can be used for shaving or outlining hairlines. Over time, the friction from repeated and extended use dulls the blades, which reduces the precision of the blades and inhibits the ability to trim beards. Dull clippers may cause cuts and ingrown hairs, which may lead to painful razor bumps. Consequently, you should sharpen the Andis T-Liner after frequent use. Knowing how perform this procedure can keep your clippers in optimal working condition and help you save money by not having to purchase a new blade.
Instructions
1. Purchase an Andis Factory Wheel blade-sharpening machine.
2. Remove the two screws keeping the Andis T-Liner clipper blade in place. Lay the clipper on a flat surface with the blade teeth pointing down to facilitate removal.
3. Brush away any loose hair or dirt from the blade. Check the black teeth to ensure that none are broken; the blade edge should be even. If any disjointedness exists along the blade edge, purchase a new blade.
4. Put on gloves and safety goggles for protection from incidental eye or hand contact between the degreasing compound and sparks generated from the sharpening machine.
5. Lubricate the blade with WD-40. Dry the blade with the cloth.
6. Place the blade on the sharpening wheel horizontally so that the red center line bisects the blade. Activate the wheel. Hold the blade in place until an even spark pattern appears across the blade.
7. Apply another coat of WD-40. Wipe the blade down with the cloth.
8. Replace the blade by situating the yoke of the blade above the pivot arm of the trimmer and aligning the screw holes of the blade with the holes found on the trimmer housing. Screw the blade into place. Avoid overtightening the screws.
Tags: Andis T-Liner, blade with, blade edge, blade place, purchase blade
No comments:
Post a Comment